This topic shows a simple interfacing of 2 GB micro SD card with PIC16F84A microcontroller. I used the PIC16F84A to read the SD card raw data which doesn’t require a microcontroller with high RAM or ROM. In this interfacing I used software SPI because the PIC16F84A doesn’t have a built-in hardware SPI module. In this […]
Interfacing PIC16F84A with SD card Read More »
In this blog there are some topics talking about the DHT11 relative humidity and temperature sensor and how to interface it with different types of PIC microcontrollers. The datasheet of the DHT11 sensor shows its characteristics and how it works. Also the following topic shows the DHT11 timing and how to simulate it using Proteus:
DHT11 Interfacing with PIC12F1822 microcontroller Read More »
Hello readers, today’s post is the first regular post on Proteus tutorial. In today’s tutorial, I am gonna share Getting Started with Proteus. Today’s tutorial is for beginners who don’t have much knowledge of Proteus but wants to start working with it. We don’t design any circuit in today’s post instead we will check the
Getting Started With Proteus Read More »
5-Channel IR remote control system using PIC microcontroller This topic shows how to make a simple infrared (IR) remote control system using the microcontroller PIC12F1822. This IR system has two circuits as known: IR transmitter circuit and IR receiver circuit. Both circuit based on the same microcontroller type which is PIC12F1822. This IR system uses
IR Remote control transmitter and receiver using PIC12F1822 microcontroller Read More »
Hello friends, hope you all are fine and enjoying good health. Today I am posting the next part of Proteus tutorial which is Interfacing of LCD with PIC Microcontroller. . In the previous post of this tutorial, we have seen the basics of Proteus and discussed various functions of Proteus ISIS. If you are new
Circuit Designing of LCD with PIC Read More »
Hello friends, hope you all are fine and enjoying good health. In the previous posts, we have seen How to design a 5V DC power supply in Proteus ISIS and after that we have also discussed How to design a variable DC Power supply using LM317.So, now today we will check how to design a
DC Motor Drive Circuit in Proteus ISIS Read More »
This topic shows an easy and effective way for decoding IR (Infra-Red) remote controls that use Philips RC-5 communication protocol, but first we’ve to understand how the RC5 protocol works. This Wikipedia links has good infos about the RC5 protocol. The RC-5 protocol was developed by Philips in the late 1980s as a semi-proprietary consumer
RC5 IR Remote Control Decoder with PIC12F1822 Microcontroller Read More »
Hello friends, hope you all are healthy, wealthy and wise. Today’s topic is about the control of stepper motor. In the last post we have seen How to control DC motor in Proteus, and now we are gonna see How to design a Stepper Motor Drive Circuit in Proteus ISIS. Stepper motors are usually of
Stepper Motor Drive Circuit in Proteus ISIS Read More »
This topic shows how to drive 5V unipolar stepper motor in 3 modes one-phase, two-phase and half step. The microcontroller used in this project is Microchip PIC12F1822 and the motor drive circuit is ULN2003. Usually the unipolar stepper motor has 5 wires one for motor supply and the other for coils. This motor has 4
Unipolar Stepper Motor Control Example with PIC12F1822 Microcontroller Read More »
This is a simple project showing you how to read LM35 analog temperature sensor using a PIC microcontroller and six seven segment (common cathod).In this tutorial we will make a practical use of multiplexed seven segment displays. We will use them to show current temperature usinga LM35 temperature sensor. The temperature sensors are connected to
Digital Thermometer using PIC16F877A and LM35 Read More »
