How To Use PIC Microcontroller For Voice Input And Output- (Part 23/25)
How To Use PIC Microcontroller For Voice Input And Output- (Part 23/25) Read More »
channel
5 Essential YouTube Tools for Turning Your Channel Pro
15 years ago YouTube was just starting, Instagram didn’t even exist, and people were just starting to figure out how to make money using the internet. Now the possibilities for making a real income using an internet platform are endless. Professional YouTubers are everywhere now, and making great money doing it. If you’re looking to
5 Essential YouTube Tools for Turning Your Channel Pro Read More »
MOTM Compatible Dual Channel Quantizer
Introduction: This describes my original design dual channel quantizer inspired by Chris List’s ARP Style CV Quantizer design. My new implementation is an intelligent design that exploits the programmability of a Microchip PIC16F84. It will quantize voltages in 1/12 volt (semitone) or 1 volt (octave) steps from –10V to 10V. Quantization time is about 2ms
MOTM Compatible Dual Channel Quantizer Read More »
8 Channel PWM LED Chaser for 16F628A and 16F88
Description This neat little circuit provides 8 LEDs directly driven from the PIC along with a single mode control switch. The firmware elsewhere on this page drives the LEDs with a 5 bit PWM signal providing each of the 8 LED channels with four levels of intensity; off, dim, mid, bright. A number of sequences
8 Channel PWM LED Chaser for 16F628A and 16F88 Read More »
Two-Channel PC Based Oscilloscope USB
Inroduction More and more experiments are now ‘PC-assisted.’ Also conventional acquisition systems are very expensive. Since portable PCs are today common and a USB link is a better solutionhere we present an oscilloscope using USB port of the PC that operates at up to 10 kHz with ±16V input voltage. It has much more improved features than the PC-based oscilloscope . The oscilloscope uses IC
Two-Channel PC Based Oscilloscope USB Read More »
4 Channel DMX512 Driver for PIC16F688
Description This project is a 4 channel DMX512 driver board. It features four power MOSFETs that can be configured to operate in PWM mode or as on/off outputs. The driver can be configured to use any four consecutive addresses across the full 512 channel address range. It can be used to drive LED arrays or
4 Channel DMX512 Driver for PIC16F688 Read More »
8 Channel IR Remote Control
This IR remote control that you can use to control other devices or circuits up to 8 devices. The control codes are sent in RC5 format modulated to about 38 kHz carrier frequency.The IR transmitter powered by the CR2016 which is a 3V button Cells Battery CR2016.To extend the life of the battery this is
8 Channel IR Remote Control Read More »