NASE 2 Tools Nano Rework station is one of the best solutions for soldering and rework of SMD componentsrequiring the highest precision. It works simultaneously with the NT115-A Nano Handpiece and the AN115 Steady Nano Tweezers. The short distance from the tip to the handle offers maximum control even when using a microscope. Temperature Dynamic Profiles The NASE-C comes with the […]
NASE 2 TOOLS NANO REWORK STATION FROM JBC TOOLS Read More »
Thermal printer is often referred as receipt printer. It is widely used in restaurants, ATM, shops and many other places where receipts or bill is required. It is a cost-effective solution and very handy to use from the user’s side as well as from the developer’s side. A thermal printer uses a special printing process which
Thermal Printer interfacing with PIC16F877A Read More »
Sensirion, the expert in environmental sensing, presents the new pin-type relative humidity sensor SHT85 for easy replaceability in a wide range of applications. The digital humidity sensor SHT85 is Sensirion’s best-in-class humidity sensor with pin-type connector for easy integration and replacement. It builds on a highly accurate and long-term stable SHT3x sensor that is at
Pin-type Humidity Sensor Enabling Easy Replaceability Read More »
The Interuniversity MicroElectronicss Centre (IMEC) is an independent research center which deals with nanoelectronics and digital technologies. Their headquarters are situated in Leuven, Belgium. Recently IMEC began to research and prototype Solid State Lithium-ion batteries. Solid State batteries are batteries which make use of solid electrodes and electrolytes. There have been a lot of research
Solid State Li-ion Batteries – High Energy-Dense Batteries Are Closer Than Before Read More »
For my current project I searched for a good boost power converter which is able to deliver continuous 400mA power for various sensors. There are an endless number of good boost converters around, but not many can be hand soldered to a board. I would really like to see some like the TPS61092 with SOIC or similar
TESTING THE TPS61092 BOOST CONVERTER Read More »
The terahertz (THz) region, which is based on 1THz frequency, separates electronics from photonics and has been difficult to access for ages. Semiconductor electronics cannot handle frequencies equal to or greater than 100GHz due to various transport-time related limitations. In other hand, photonics devices fail to work below 10THz as photon’s energy significantly drops to thermal energy. Terahertz
Finding a way to deposit vertical dielectric barriers has allowed Litecool of Sheffield to make dramatic cut in LED thermal resistance – from 1.25 to 0.5°C/W is one case – see diagram. Dielectric layers are essential to separate electrical conductors but, with a few notable exceptions like diamond, introduce thermal barriers. Spreading heat before it
Sheffield firm slashes LED thermal resistance Read More »
The exterior conceals new technology behind the bezels that make possible such features as adaptive beams and LED matrix beams, for example. Often, each LED has its own lens that is held by a fixture, and light guides with small saw-tooth structures to direct the light to the road and to the external viewer are
LED car headlight design can benefit from thermal simulation, says Mentor Read More »
It´s surely not necessary to remind that any device can fail. Failure of a component, overload of a component (underestimated sizing), external influence and many other reasons are daily causing failures of devices. If the result of a malfunction is only an intermediate shutdown, it´s let´s say a better case. But if a device malfunction
They act only ones – right then, when it´s really necessary Read More »
