module

GSM interfacing with PIC microcontroller receiving call

GSM module Interfacing with PIC Microcontroller – Make and Receive Calls

GSM Interfacing with PIC Microcontroller PIC16F877A – Make and Receive Calls GSM modules are fascinating to use especially when our project requires remote access. These modules could make all actions that our normal mobile phone could do, like making/receiving a call, sending/receiving a SMS, connecting to internet using GPRS etc. You can also connect a

GSM module Interfacing with PIC Microcontroller – Make and Receive Calls Read More Ā»

F16KCVJIY4QBS1Z.MEDIUM

Latching Relay Module

In electronics, a device is said to be a latching device if it maintains any particular fixed state even after removal of the input signal. The same also applies for electronic/electromechanical relays. Basically the electromechanical relays that are used today are of two types: 1. Non-Latching Relay : These relays are most widely used where

Latching Relay Module Read More Ā»

LTM8003 40VIN 3.5A Step Down Ī¼Module Regulator

LTM8003 – 40VIN, 3.5A Step-Down Ī¼Module Regulator

Features Complete Step-Down Switch Mode Power Supply Wide Input Voltage Range: 3.4V to 40V Wide Output Voltage Range: 0.97V to 18V Wide Temperature Range: ā€“40Ā°C to 150Ā°C (H-Grade) 3.5A Continuous Output Current, 6A peak FMEA Compliant PinoutĀ Output Stays at or Below Regulation Voltage DuringĀ Adjacent Pin Short or if a Pin Is Left Floating Selectable Switching

LTM8003 – 40VIN, 3.5A Step-Down Ī¼Module Regulator Read More Ā»

DS1307 RTC Module

DS1307 RTC Module

The module based on DS1307, The DS1307 serial real-time clock (RTC) is a low-power, full binary-coded decimal (BCD) clock/calendar plus 56 bytes of NV SRAM. Address and data are transferred serially through an IĀ²C, bidirectional bus. The clock/calendar provides seconds, minutes, hours, day, date, month, and year information. The end of the month date is

DS1307 RTC Module Read More Ā»

LTM8064 58VIN 6A CVCC Step

LTM8064 – 58VIN, 6A CVCC Step- Down Ī¼Module Regulator

Features Complete Step-Down Switch Mode Power Supply CVCC: Constant-Voltage, Constant-Current 2-Quadrant: Sources and Sinks Output Current Parallelable for Increased Output Current,Ā Even from Different Voltage Sources Adjustable Output Current Up to 7A WhenĀ Sourcing or 9.1A When Sinking Wide Input Voltage Range: 6V to 58V 1.2V to 36V Output Voltage Selectable Switching Frequency: 100kHz to 1MHz (e1)

LTM8064 – 58VIN, 6A CVCC Step- Down Ī¼Module Regulator Read More Ā»

Lux Meter Module

Lux Meter Module

LUX Meter project has been design to measure the illumination.Ā  Illumination is luminous flux falling on surface area of photo diode.Ā  This illumination converted to corresponding voltage using Op-Amp circuit. Specifications Supply 9 VDC PP3 Battery @ 20 mA Ā Onboard Photo Diode Ā Onboard preset for calibration Ā Range selection via jumper 10mV/LUX, 1mV/LUX, 0.1mV/LUX Ā Interfacing is

Lux Meter Module Read More Ā»

MRNet Wired Cab Module Revision A

MRNet — Wired Cab Module (Revision A) using pic microcontroller

Table of Contents Table of Contents Introduction Cab Design Goals Cab Electronics Power and Cable Interface Microcontroller Seven Segment Display Buttons LED’s Cab Printed Circuit Board Cab Software Summary Ā Introduction {Introduction goes here.} Cab Design Goals The goals for the handheld cab are: Light weight. Comfortable. Not visibly warm (i.e. low power consumption). Assembled from

MRNet — Wired Cab Module (Revision A) using pic microcontroller Read More Ā»

1A from the sugar cube sized module

1A from the sugar cube sized module

he TSR1SM series models of step-down switching regulators (non isolating ā€“ POL) have a high efficiency up to 96 % which allows full load operation up to +65Ā°C ambient temperature without the need of any heat transmission layer. Excellent output voltage accuracy (Ā±2%) and low standby current (~1 Ī¼A) are features that distinguish these switching

1A from the sugar cube sized module Read More Ā»