Summary of PICMICRO THE SERVO MOTOR SERIAL PORT CONTROL PROJECT
This project explains how to control eight servo motors using a PIC16F876 or PIC16F877 microcontroller via a serial RS232 connection from a PC. The PIC's PORTB pins connect to the servos' control signals, while serial communication uses pins RC6 and RC7. The servos require separate power due to high current draw. The PIC must be programmed with specific configuration flags using provided C source code, and a PC application (Servo Test) is included for controlling the servos.
Parts used in the Servo Motor Serial Port Control Project:
- PIC16F876 or PIC16F877 microcontroller demoboard
- RS232 serial module
- Personal Computer with serial port
- Eight servo motors (or substitute with a single servo if fewer)
- Power supply for the microcontroller board
- Separate power supply for the servo motors
- Connecting cables for signals and power
- Software: C source code for PIC programming
- PC application "Servo Test" for servo control
PIC16F877 pic16f876 via the serial port and control the servo motor with 8 additional program code in addition have prepared for the test sample c language To follow this project need to arm themselves demoboard 16F876 (or 16f877), the… Electronics Projects, PICmicro the Servo Motor Serial Port Control Project “microchip projects, microcontroller projects,
PIC16F877 pic16f876 via the serial port and control the servo motor with 8 additional program code in addition have prepared for the test sample c language
To follow this project need to arm themselves demoboard 16F876 (or 16f877), the RS232 module, a PC serial port and 8 servants well. If you do not have home-8 servants, you can also use a door solo.Alle B of the PIC will be connected wireless signal of the servants and the rs232 module connects to the pins RC6 and RC7. You can connect the PC to the serial form rs232, program the PIC and install the control program in your PC.
Connections have to do this: Connect the pin port B line to the control of the 8 servi.Collegare the pin RC6 (17-pin serial Tx) to form rs232 and pin RC7 (18-pin serial Rx) always form rs232.Alimentate demoboard is that the module rs232.I servants should feed them separately because their absorption in the stream may be such as to reset the pic.
executable code to be included in the pic. You have to program the pic with the flag XT and power up timer activated, leave off all other flags. Source code written in C for the pic. I preferred to leave it in a way so as not to fill the page with a list a little lunghetto. PC program Servo Test in ZIP format. Designed by Emanuele Secchi, so you have to unpack and install on your PC.
Source: http://www.fisertek.it/index_000032.html PICmicro the Servo Motor Serial Port Control Project souce code etc. files Alternative link:
FILE DOWNLOAD LINK LIST (in TXT format): LINKS-4814.zip
Source: PICMICRO THE SERVO MOTOR SERIAL PORT CONTROL PROJECT
