Microchip do not recommend any particular circuit for ICSP programming. There are diagrams for different tools, such as Pro Mate and PICKit2 with similar circuitry but slight variations. In some schematics, their suggested resistor values are too small, in our opinion, and can cause problems with programmers, even Microchip ones. Microchip PIC Programmer ICSP Circuit […]
Microchip PIC Programmer ICSP Circuit Requirements Read More »
Crime in general is still on the rise, and having a security alarm installed is no longer a perquisite of the wealthy! Here is a simple and compact security alarm system to protect your home/shop and valuables. The circuit is built around a tiny microcontroller chip PIC12F675. Besides, a ready-made Passive Infrared (PIR) module is
PIC12F675 Microcontroller Based Security Alarm Circuit Read More »
In this article I used in banks and hospitals will give information about the Q-matic s. I’ve done a routing circuit board (main board) and consists of three separate teller. Routing PIC16F877 on board, if the teller did not use pic16f876 in each. Teller as the officer may increase, decrease or can be reset. Every
Q-matic Circuit Application of PIC16F877 Microcontroller Read More »
Electrical accidents are rapidly increasing especially electric line repairs incident due to the lack of communication and coordination between the maintenance personnel and the electric substation staff. The password based circuit breaker device could just be the solution as only the lineman could reliably control the circuit breaker to avoid miscommunication. The system requires a
Password Based Circuit Breaker Read More »
The infrared (IR) is invisible radiant energy, electromagnetic radiation that we cannot see with our eyes, but we can sometimes feel on our skin as heat. The infrared light falls just outside the visible spectrum, beyond the edge of what we can see as red. Most of the thermal radiation emitted by objects near room
Passive Infrared Detector Circuit Read More »
Features in-circuit programmer programs flash PICmicro’s supports a rapid cycle of code/program/test prototype programmer takes power from the target circuit serial interface serial passthrough to the target Foremost Wisp628 is an in-circuit programmer. The programmer is connected to a few pins of the target PICmicro, which is programmed while it remains in the circuit.
Wisp628 an in-circuit flash PICmicro Programmer Read More »
Description This circuit can be used to operate an electric strike or an electromagnetic lock on a door. It is not the door being opened/closed, but a small electromagnetic strike which unlocks the door. The opener has the following features currently programmed in software: automatic operation when a guest pushes the doorbell, the strike is
Automatic door opener with PIC12C508 Circuit Read More »
For a long time I needed a good programmer pussy, even if it is programming, so from time to time the application gets where it is used. So I decided to build the programmer. I chose between a couple of projects from different authors, but eventually won PICkit2. Microchip released the schema directly in the
Circuit-Zone.com – Electronic Projects Read More »
Usually high level quiz competitions are very much time-oriented as it becomes significant to determine who has answered first. So here we’ll see how to make a buzzer system that helps to decide the winners. Actually I designed this circuit of buzzer for quiz program conducted in our area and then I thought it may
Electronic Quiz Buzzer Circuit Diagram using PIC Microcontroller Read More »
The SiT5003 is the most flexible LVCMOS/LVTTL/HCMOS compatible, ultra-stable MEMS VCTCXO (Voltage Controlled, Temperature Compensated Oscillator) solution in the market. This device supports any combination of the following features: frequency (1 – 80MHz), voltage (1.8V, 2.5V-3.3V), stability (±0.5PPM), pull range (±12.5PPM to ±50PPM) and 4-pin packages (3225, 5032, 7050). It provides superior shock and vibration
Temperature compensation delivers from MEMS oscillator Read More »
