News & Updates

Seco’s New i.MX8M And i.MX8Quad Based Modules Run Linux 1

Seco’s New i.MX8M And i.MX8Quad Based Modules Run Linux

Seco Embedded Creators have launched the i.MX8M based Q7-C25 and i.MX8Quad based Q7-C26. Both can run Linux and Android, and are available in 0 to 60°C and -40 to 85°C models. The 5V modules have many similar features, but the Q7-C26 based on the more powerful, up to hexacore i.MX8Quad adds some extras such as SATA III support. The Q7-C25 utilizes NXP’s dual- […]

Seco’s New i.MX8M And i.MX8Quad Based Modules Run Linux Read More »

Particle sensor with LoRa

Particle sensor with LoRa

Two PCBs from earlier projects were used in this project: LoRa breakout board Sensor PCB with Si7013 humidity sensor from multisensor LoRa project … and particle sensor. Particle sensors could be cheap and easy to use. Disadvantage of lowest cost PM sensors is lack of “calibration”. The best method to measure particle content dispensed in

Particle sensor with LoRa Read More »

MintBox Mini 2 comes with more power and it is 50 faster than its predecessor.

MintBox Mini 2 comes with more power and it is 50% faster than its predecessor.

The first MintBox Mini was released in 2015 in partnership between Compulab and the Linux Mint team. Since then, there has been an advancement in the software and the hardware that powered the first iteration. In March 2018, Compulab has continued with the Linux Mini Project releasing a replacement for the AMD A10 based MintBox Mini

MintBox Mini 2 comes with more power and it is 50% faster than its predecessor. Read More »