Mini Digital Barometric Altimeter




I found on Ebay very nice, small 12v 23A battery holders for PCB mounting style and decided to fit the SMALL DIGITAL BAROMETRIC ALTIMETER just on the back of the holder.

Mini Digital Barometric Altimeter

So basically this is the same schematic as the SMALL DIGITAL BAROMETRIC ALTIMETER, however I moved some of the connections to different MCU pins because of PCB space limitations.

In spite of the small size the functional remains the same.

– 128Kb EEPROM memory which allows approximately 3.5 minutes of recording
– 40 record per second
– Blink integer values up to 9999 meters
– USB connector for memory download
– 13 bit ADC resolution trough oversampling
– 1m per bit resolution
– On the field it will calculate and show maximum altitude
– Temperature adjusted for 20 degrees Celsius
– ICSP programming capability
– Auto start detection

After that the PCB was a bit of a challenge with those small dimensions but I managed to fit everything on a 36×12 mm PCB.

Once I soldered all components the height was 5 mm.

And after I mounted the battery holder the total height is 18 mm to give the final dimensions of 36x12x18 mm.

Of course the weight is as important as the size and normally both are related so the final weight was also reduced to 4gr without battery and 13 grams with the battery.

Because this mini altimeter is intended for model/experimental rockets and thus high acceleration forces there were some concerns about how stable the battery will be held in the holder and whether the acceleration will not open the contacts and restart the device.

READ  200 chip definitions everyone should know

So taking into consideration the weight of the battery and the usual accelerations in the hobby rocketry I’ve calculated the force that the battery will apply on the metal spring. I’ve also measured the force necessary to bend the spring and there is considerable safety margin.

The only potential problem I see is that if the battery is subject somehow to horizontal acceleration it can be somehow ejected from the holder because of the spanned spring. This is of course easily fixable with a piece of insulation tape.

Read more: Mini Digital Barometric Altimeter




Leave a Comment

*
= 4 + 1

Read previous post:
THE TOP 10 LINEAR VOLTAGE REGULATORS ACCORDING TO SNAPEDA
THE TOP 10 LINEAR VOLTAGE REGULATORS ACCORDING TO SNAPEDA

In electronics, linear voltage regulators are commonly used to stabilize voltages. Regardless of the input voltages or load conditions, they...

Close
Scroll to top