Hardware Protection – OverVoltage and OverCurrent
Power processing is one of the most important aspects on electronic design. The power is unique for a typical system because it gives the system life. Before starting to make the project for a power supply we need to analyze some aspects: Which kind of radio/electromagnetic interference is the device going to face ? What about maintenance requirements? And finally which environment conditions (temperature, humidity, vibrations) will the device be exposed to?
1. Power Supply Parameters
Three major power supply (Figure 1) architectures are defined for any engineer:
2.Pulse width modulated switching (PWM).
3.High resonant technology switching.
Vin(low), Vin(high) – minimum and maximum allowed input voltages, hence input voltage range.
Iin(max) – maximum average input current.
Vout(min), Vout(max) – minimum and maximum allowed output voltages, hence output voltage range.
Vout(abs) – maximum allowed output voltage this limit is set by load specs. Iout(rated), Iout(min) – maximum and minimum output current provided to the load. Isc – short circuit output current.
When some of these inputs/outputs parameters are not correlated with their optimal values or just when some external event disturbs the system, like dropout, surge, transients, ripple voltages, the entire system is vulnerable and need to be protected. Everyone knows that is better preventing than curing. The solution for this is permanent monitoring and auto controlling. In most of the cases an electronic circuit is build for controlling a specific load (it’s the outpu
For more detail: Hardware Protection – OverVoltage and OverCurrent
EasyEDA: Ideas for Circuit Design, Innovation for Electronics Access
Free Circuit Design: Schematic – Simulation – PCB Layout – Gerber Viewer
Cheapest PCB Prototype: Only $2 for 10pcs 10×10cm PCBs, 24 hours Quick Turn, DHL Delivery in 3 Days
Current Project / Post can also be found using:
- pic overvoltage project