Low Power ESP8266 – Sleeping at 78 micro Amps




I recently bumped into NodeMCU firmware for the ESP8266. It’s an Lua interpreter, making tinkering with IoT ideas really simple. Just flash the firmware onto the ESP8266 and connect via serial console. You can start prototyping right away using the interactive Lua interpreter. You can easily persist your ideas on a simple flash file system.

For convenient development, there is ESPlorer, a basic IDE for Lua on the NodeMCU. It allows you to develop the Lua scripts locally and then save them to the MCU via serial protocol.

Low Power ESP8266 – Sleeping at 78 micro Amps

To make developing with the ESP-01 module easier, I created a basic development board. It provides easier access to the individual pins, has jumpers for flashing mode (GPIO00) and enable (CH_PD), offers a button for reset, and also integrates a socket for a step-down power supply.

this is not available straight away on the ESP-01 module, as the ‘post-sleep-reset-pin’ XPD_DCDC (8) of the MCU is not connected to the reset pin. I solved this by manually soldering a single wire of a stranded cable between the reset pin of the module and the XPD_DCDC (8) pin of the MCU (bottom right corner of the mcu in the first photo). On top of this, I also removed the red power LED by simply prying it off with a tiny screw driver.
With these two modifications, the module is able to make use of the deep-sleep mode and successfully resets and restarts after waking.

For more detail: Low Power ESP8266 – Sleeping at 78 micro Amps

 




Leave a Comment

*
= 4 + 6

Read previous post:
Output Blink port For CSS Compiler

#include <16F877.h> #device adc=8 #FUSES NOWDT ,XT #use delay(clock=4000000) void main() { set_tris_b(0x00); setup_adc_ports(NO_ANALOGS); setup_adc(ADC_OFF); output_b(0x00); while(true){ output_b(0xff); delay_ms(500); output_b(0x00);...

Close
Scroll to top