Teardown and experiments with a Doppler microwave transceiver




I got a couple of Microsemi’s C900502 10.525 GHz X-band Doppler radar motion sensors a while ago. This batch was made in UK and had “UK patents 2243495 and/or 2253108 apply” printed on the case. I have seen a teardown of an HB100 Doppler radar module before and was wondering if I this one is any different inside.

The C900502 transceiver has a very sturdy metal casing. It is measured at roughly 5cm by 5cm by 1cm. The transmitter and receiver antennas are patch antennas etched directly onto the PCB as you can see from the picture below:

Teardown-and-experiments-with-a-Doppler-microwave-transceiver

On the back side you can see the patent number stamped onto the casing. There is an adjustment hole underneath the model number sticker. Using a screw driver, you can make fine adjustments of the transmitted frequency. Using this module is simple and only three connections are required: +5V, ground, and IF output.

Here is a picture of the back shielding removed. The shielding is divided into two compartments, one for the oscillator and the other houses the mixer. You can see some RF absorbing strips inside the oscillator compartment, this is to reduce the oscillator leakage into the mixer.

And here is a picture of the circuit board. It is surprisingly elegant, only 5 discrete components (two active components and three passive components) are used. The board layout is strikingly similar to that of HB100. Perhaps HB100 is based on the same patents?

Here is a closeup of the oscillator portion. The oscillator consists of a single FET. The brown cylindrical component is a dielectric resonator. Note that it is not physically connected to any other components. The coupling is achieved strictly via the electromagnetic fields outside the cylindrical boundary of the dielectric resonator. The resonant frequency (TE01n mode) of the dielectric resonator can be calculated as:

fGHz=34araL+345 

where the relative permittivity of the dielectric material is usually between 30 and 50. Barium titanate(BaTiO3) is a common material used for the dielectric resonator.

READ  UART Example for PIC16F887 microcontroller using CCS PIC C compiler

You can also see many distributed element filters on the PCB. Here you can see two radial stubs.

Read more: Teardown and experiments with a Doppler microwave transceiver

 




Leave a Comment

*
= 5 + 6

Read previous post:
NEW 24.06% EFFICIENCY RECORD FOR BIFACIAL SILICON SOLAR CELL
NEW 24.06% EFFICIENCY RECORD FOR BIFACIAL SILICON SOLAR CELL

LONGi Solar has announced that it has achieved a new monocrystalline silicon PERC (Passivated Emitter Rear Cell) world record conversion...

Close
Scroll to top