Interfacing Relay with PIC Microcontroller




A relay is an electromagnetic switch which is used to switch High Voltage/Current using Low power circuits. Relay isolates low power circuits from high power circuits. It is activated by energizing a coil wounded on a soft iron core. For detailed working of relay please visit this page. A relay should not be directly connected to a microcontroller, it needs a driving circuit.

Interfacing Relay with PIC MicrocontrollerA relay should not be connected directly to a microcontroller due to following reasons..

  • A microcontroller is not able to supply current required for the working of a relay. The maximum current that a PIC Microcontroller can source or sink is 25mA while a relay needs about 50 – 100mA current.
  • A relay is activated by energizing its coil. Microcontroller may stop working by the negative voltages produced in the relay due to its back emf.

Interfacing Relay with PIC Microcontroller using Transistor

A relay can be easily interfaced with microcontroller using a transistor as shown below. Transistor is wired as a switch which carries the current required for operation of the relay. When the pin RB7 of the PIC microcontroller goes high, the transistor BC547 turns On and current flows through the relay.

Interfacing Relay with PIC Microcontroller The diode D1 is used to protect transistor and the microcontroller from Back EMF generated in the relays coil.  Normally 1N4148 is preferred as it is a fast switching diode having a peak forward current of 450mA. This diode is also known as freewheeling diode.

Note: VDD and VSS of the pic microcontroller is not shown in the circuit diagram. VDD should be connected to +5V and VSS to GND.

 

For more detail: Interfacing Relay with PIC Microcontroller




Current Project / Post can also be found using:

  • relay with pic16f877a
  • how to connect relay to pic microcontroller
  • how to interface relay with pic microcontroller in proteus
  • how to use the relay in pic micro controller

Leave a Comment

*
= 4 + 1

Read previous post:
Digital Thermometer using PIC Microcontroller and LM35 Temperature Sensor

A Digital Thermometer can be easily constructed using a PIC Microcontroller and LM35 Temperature Sensor. LM35 series is a low...

Close
Scroll to top